Inspecting And Replacing Oil Line - Echo CS-2510TES Service Manual

CS-2510TES
50
250Ts, 250TCs
SAW CHAIN LUBRICATION SYSTEM

7-3 Inspecting and replacing oil line

{Inspecting and removing oil line}
1. Remove sprocket guard, clutch assembly, clutch
plate, clutch drum and needle bearing (Refer to "5-1
Inspecting clutch parts.").
2. Remove two bolts and muffl er cover (A).
3. Remove oiler cover (B).
B
A
4. Disconnect oil line (C) from auto-oiler assembly
(D).
5. Connect pressure tester 897803-30133 (E) to oil
D
line (C).
NOTE: To connect pressure tester to oil line (C), it
C
is recommended to use pipe joint V186-000020 (F).
F
E
F
6. Tighten oil cap and apply pressure approx. 9.8
2
kPa (0.1kgf/cm ) (1.4psi).
7. Pressure should not drop. If the pressure drops,
leakage may occur at oil line, oil cap, oil cap gas-
ket, oil tank vent, or oil tank. Inspect them and
replace defective part(s) with new part(s) as re-
quired.
NOTE: Remove oil strainer from oil line (C), before
removing oil line (C). (Refer to "7-1 Inspecting oil
cap and strainer" )
D
{Installing oil line}
C
8. Install oil line (C) to oil tank and connect oil line
(C) to auto-oiler assembly (D) as shown.
NOTE: Make sure that grommet (c) of oil line (C) is
set in engine cover.
c
9. Reassemble removed parts.