Changing The Paper Size - Canon Paper Deck Unit-B1 Installation Procedure

Changing the Paper Size

Changing the Paper Size
1) Open the compartment.
2) If the lifter of the paper deck is in up position, turn on the host machine and push down both
sensor levers (upper/lower) of the power supply position sensor inside the compartment
with your fingers so that the lifter will move to its lower limit.
3) Remove the screw, and mount the paper rear end guide plate to suit the new paper size.
4) In the same way, remove the screw (1pc.each), and adjust the position of the left/right
guide plates to suit the new paper size.
x3
Changing the Paper Size
5) In service mode, set the new paper size: LEVEL1/COPIER>OPTION>ACC>DK-P.
-When the host machine is iR ADVANCE 4045/4051 series:
0: A4, 2: LTR
-When the host machine is iR ADVANCE C5051 series:
0: A4, 1: LTR
F-1-51
NOTE:
If the size is set to LTR, it is unnecessary to use the rear end guide plate.
To find out the paper size, check the mark on the bottom plate.
NOTE:
After you have changed the paper size, be sure to turn off and then on the host
machine.
19
19