Injecting Sealant And Air - Acura MDX 2020 Owner's Manual For Quick Reference

HANDLING THE UNEXPECTED
4. Pull the handle on the cargo area
floor lid and open the lid.
5. Take out the cargo floor box.
6. Take the kit out of the case.
7. Place the kit face up, on flat ground
near the flat tire, and away from
traffic. Do not place the kit on its
side.
150 |
n

Injecting Sealant and Air

1. Remove the valve cap from the tire valve stem.
2. Remove the sealant/air hose from the packaging.
3. Attach the sealant/air hose onto the tire valve stem. Screw it until it is
tight.
4. Plug in the compressor to the accessory power socket. Be careful not to
pinch the cord in a door or window.
5. Start the engine. Keep the engine running while injecting sealant and
air.
6. Turn the selector switch to REPAIR (for U.S. models) or SEALANT/AIR
or PRODUIT ANTIFUITE/AIR (for Canadian models).
7. Press the inflator switch to turn on the compressor. The compressor
starts injecting sealant and air into the tire. When the sealant injection
is complete continue to add air.
8. Models with 265/45R20 104V tires: After the air pressure reaches 35
psi (240 kPa) /rear 32 psi (220 kPa), turn off the kit. To check the
pressure, occasionally turn off the compressor and read the gauge.
9. Models without 265/45R20 104V tires: After the air pressure reaches
35 psi (240 kPa), turn off the kit.
10. Unplug the power plug from the accessory power socket.
11. Unscrew the sealant/air hose from the tire valve stem. Reinstall the
valve cap.
12. Press the pressure relief button until the gauge returns to 0 psi (0 kPa).
13. Apply the speed restriction label.
14. Apply the repair notification label to the flat surface of the wheel. The
wheel surface must be clean to ensure the label adheres properly.
HANDLING THE UNEXPECTED
| 151