Juniper ACX5096 Quick Start Manual page 14

Permit only trained and qualified personnel to install or replace router components.
Perform only the procedures described in this quick start and the ACX5000 router documentation. Other
services must be performed only by authorized service personnel.
Before installing the router, read the planning instructions in the ACX5000 router documentation to
make sure that the site meets power, environmental, and clearance requirements for the router.
Before connecting the router to a power source, read the installation instructions in the ACX5000 router
documentation.
The ACX5096 router weighs approximately 32.5 lb (14.74 kg). Manually installing the ACX5096 router
in a rack or cabinet at a height above 60 in. (152.4 cm) requires two people to lift the router and install
mounting screws. To prevent injury, keep your back straight and lift with your legs, not your back.
If the rack or cabinet has stabilizing devices, install them in the rack before mounting or servicing the
router in the rack or cabinet.
Before installing or after removing an electrical component, always place it component-side up on a flat
antistatic mat or in an antistatic bag.
Do not work on the router or connect or disconnect cables during electrical storms.
Before working on equipment that is connected to power lines, remove jewelry, including rings, necklaces,
and watches. Metal objects heat up when connected to power and ground and can cause serious burns
or become welded to the terminals.
CAUTION: Do not place a copper transceiver in an access port directly above or below
another copper transceiver. Damage to the access ports will occur.
WARNING:
another product.
Power Cable Warning (Japanese):
The attached power cable is only for this product. Do not use this cable for
14