Kenmore 721.8758 Series Use & Care Manual page 34

The following issues are not covered under the warranty:
Problem
Unit has no power
Vent is not working
- Weak or no ventilation
- Abnormal noise during
operation
- Product overheating
The cost of repair or replacement under these excluded circumstances shall be borne by the consumer.
Cause
1. House power turned off (power supply)
2. Tripped breaker
3. The power cord is not installed properly
1. Improper blower unit direction or installation
2. Improper ductwork or damper connection
Exhaust Adapter
Slide exhaust
adapter into
guides on
rear panel.
Damper
(hinge side up)
Locking
Tabs
Guides
- 34 -
Solution
1. Check house power supply
2. Check proper power cord
connection
3. Check extension cord
1. Check blower unit direction and
reinstall if necessary.
2. Properly align the exhaust
ports and blower plate opening.
3. Blower unit exhaust ports
should be completely exposed
to the outside
4. After installation, check the air
ventilation path