Using Cd Effects - Tascam CD-VT1MKII Owner's Manual

Using CD effects

(continued from the previous page)
CAUTION
If you set the key control to O 6 while the fine
tuning value is greater than 0, the fine tuning
value is automatically reset to 0. Similarly, if
you set the key control to I 6 while the fine
tuning value is less than 0, the fine tuning
value is automatically reset to 0.
Also note that when key control or VSA is
ON, you may find that the music played back
has a "vibrato" feel. This is not a fault of the
CD player – it is a natural result of the special
effects.
Using CD effects
Turning CD effects on and off
Pressing the CD EFF switch at the side
of the CD-VT1MKII turns on the
CD effects: vocal cancel, mono moni-
tor, split monitor. The
CD EFF
shown on the display when the switch
is ON. Press the CD EFF
to turn off the CD effects.
Vocal Cancel
The vocal cancel function reduces the
volume of a chosen region of the stereo
18
— TASCAM CD-VT1MKII
image in a chosen frequency range.
On / Off
Tap the CD EFF/SETUP
the CD Effect menu, and choose
to turn the vocal canceller on or off.
Setting the stereo region to be
reduced
Tap the CD EFF/SETUP
the CD Effect menu, and choose
to set the value of the localization to be
reduced.
The value can be selected from L10
– L1, C, R1 – R10.
Setting the frequency range to be
reduced
Tap the CD EFF/SETUP
the CD Effect menu, and choose
to select either
symbol is
(all range).
switch again
NOTE
• You may not get the full effect of the vocal
cancel function on some tracks.
• When the vocal cancel effect is on, the ste-
reo sound of the CD playback may not seem
quite as vivid.
key to enter
CNCL
key to enter
PART
key to enter
RNGE
(mid range) or
MID ALL
Mono monitor
Setting the monitor mode allows you
to control the output signal between
mono and stereo with alternate options
for both.
Tap the CD EFF/SETUP
the CD Effect menu, and select
by pressing either the PREV
key. Press either the UP or
to select from the following:
 : outputs a mono signal, mix-
L+R
ing the L (left) and R (right) chan-
nels.
 : outputs the L channel signal
L
only.
 : outputs the R channel signal
R
only.
 : outputs normal stereo signal.
OFF
Split monitor
Setting the split monitor mode allows
you to split the CD output and the
microphone(s) into left and right out-
puts.
(continued on the next page)
key to enter
MONO
or NEXT
DOWN key