Copy ® Insert; Move ® Paste - Tascam DP-02 Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS
COPY INSERT
®
This function takes the section of a track or tracks marked
by the IN and OUT points, copies it, and inserts it on the
chosen track or tracks, as new material, starting at the TO
point.
The original source is left unchanged.
The insert operation adds the selected section as new mate-
rial to the destination. Nothing is overwritten at the desti-
nation, as any existing material following the TO point is
moved to the end of the newly-inserted section. The track
is now longer than it was before the operation.
You can copy the section more than once in one operation
(for example, to repeat a verse/chorus section).
IN OUT
IN OUT
MOVE PASTE
®
This function takes the section of a track or tracks marked
by the IN and OUT points, and moves it to the chosen track
or tracks, starting at the TO point.
After the operation, the selected section of the source
between the IN and OUT points is replaced by silence.
This operation overwrites anything which is already
recorded at the destination. The track is therefore the same
length as it was before the operation.
IN OUT
IN OUT
2 – Advanced techniques
TO
TO
TO
TO
You can change the following values:
SOURCE.TRK This sets the source track or tracks from
which the section is copied. Choose 1 through 8 to select
an individual track. Choose 1/2, 3/4, 5/6 or 7/8 etc. to select
a pair of tracks. Choose 1-8 to select all tracks.
DESTINATION. TRK This sets the destination track or
tracks into which the selected section is inserted. What you
can select here depends on what you have selected for the
source track. If you have selected a single track, you can
select tracks 1 through 8 here. If you have selected a pair
of tracks (for instance, 1/2), you can only select track pairs
here. If you have selected all tracks (1-8), then 1-8 is the
only option available to you here.
COPY TIMES This is the number of times that the select-
ed section is inserted (end-to-end) in the destination track
or tracks. You can set this value from 1 to 99.
Press YES/ENTER to perform the operation or
leave this screen.
You can change the following values:
SOURCE.TRK This sets the source track or tracks from
which the section is taken. Choose 1 through 8 to select an
individual track. Choose 1/2, 3/4, 5/6 or 7/8 to select a pair
of tracks. Choose 1-8 to select all tracks.
DESTINATION. TRK This sets the destination track or
tracks to which the selected section is moved. What you
can select here depends on what you have selected for the
source track. If you have selected a single track, you can
select tracks 1 through 8 here. If you have selected a pair
of tracks (for instance, 1/2), you can only select track pairs
here. If you have selected all tracks (1-8), then 1-8 is the
only option available to you here.
Press YES/ENTER to perform the operation or
leave this screen.
TASCAM DP-02/DP-02CF
NO/EXIT to
NO/EXIT to