Basic Operations; Power-Up Procedure; Power Down; Inserting Discs - Tascam CD-D4000 MKII Owner's Manual

4 - Basic operations

4.1 Power-up procedure

When the unit is first powered up using the power
switch 1, it performs a self-check operation, and the
screen shows the following:
T A S C A M
C D - D 4 0 0 0
:
followed by
T A S C A M
I n i t i a l i z i n g
If the self-check is passed, the display will show the
first menu screen, otherwise an error message will be
displayed.

4.2 Inserting discs

Press the eject button of the MASTER or the
SLAVE drive to open the disc tray.
Place discs label side uppermost in the disc tray.
To insert the discs into the MASTER drive, you may
find it useful to place the front of the disc into the
disc tray first, and then seat the back of the disc into
the tray.
If a disc is placed into a tray upside-down or off-cen-
ter, an error message will appear on the display.
You can close the disc trays by pressing the eject but-
ton on the drive (though many operations will close
the disc trays automatically).
M K 2

4.3 Power down

Before powering down the unit, eject discs from both
drives (the eject mechanism requires power to work,
and so you will not be able to eject the discs once
power is turned off).
NOTE
Do not turn off the CD-D4000 MKII while writing to
the slave disc (i.e. part of the way through a disc
copy operation. If you do, the disc will be corrupt,
and unusable.
4.4 Modes
The different modes available are:
• Copy
• Test write
• Compare CD-ROM
• Play audio
• Write speed selection
These are accessed by pressing the MODE key.
Details of these modes are given below.
When the required mode is shown on the lower line
of the display, press the ENTER key to enter the
mode.
When the word Exit appears on the display, the
ENTER key will halt the current operation.
TASCAM CD-D4000 MKII
7