Table of Contents
Advertisement
Dubbing from tape to disc
When dubbing from tape to disc, follow the instructions here.
1 Load the tape with the side that will be recorded first
to be played first. Set the noise reduction, reverse
mode, etc. Also, check the
2 Load a recordable disc.
3 Use the
MENU
key until
the screen. Use the
MULTI DIAL
bypass the input level control (see "Bypassing the
input level for dubbing" on page 23).
If you want to adjust the input volume, set the
menu to
and use the CD deck's
DUB >VOL
ON
control to adjust the level of signals. If you
INPUT
wish to adjust the volume before recording starts,
put the CD-RW into record standby or Monitor
mode (see "Input monitoring on page 20") and use
the
key to select TAPe.
INPUT 1 SEL
4 Press the
key.
DUB 1
The CD goes into record standby. The tape rewinds
to the start of the tape and starts playing back. The
CD recorder starts recording.
Dubbing to CD from the middle of the tape
1 To record from the middle of the tape, set noise
reduction, reverse mode, etc. and locate the tape to
the position where playback will start.
2 Press the tape
PAUSE
key to leave the tape in
paused mode.
3 With a recordable disc in the drive, press the
key. The tape will start playing back, and the disc
1
will start recording.
Recording stops under the same circumstances as
for the whole tape (end of tape, end of disc or either
key pressed).
STOP
Bypassing the INPUT level for dubbing
The input control can be bypassed so that it has no effect
when dubbing, in the following way:
1 Press the menu key until the
pears.
2 Turn the dial to select
and disabled.
NOTE
This setting applies only to dubbing procedures, not to
other recordings.
It is not possible to make this menu setting (or other
menu settings) when dubbing is actually taking place.
is set
.
MONITOR
DISC
appears on
DUB >VOL
to select
to
THRU
DUB
item ap-
DUB >VOL
, the control is bypassed
THRU
5 – Recording CDs
1- Introduction
5 When the available recording time on the disc is
finished, or the tape has stopped, then recording
will stop on the disc.
You can also stop the dubbing process by pressing
either of the
keys.
STOP
NOTE
A recordable disc must be loaded in the drive. The
DUB 1 key is disabled if the media are not loaded, and
if the drives are in any mode other than stop.
TASCAM CC-222SL
Advertisement
Table of Contents
