Table of Contents
Advertisement
18
ASSEMBLING AND PREPARING
Set mount screw
NOTE
Use a M8 screw for a wall mount screw
y
hole.
The insertion depth of the screw should
y
be at least 8 mm.
Cautions on installation
Stand type
Screw
- Do not install the product in a location where
vibration or shock is likely to occur. Objects may
be dropped on the product causing damage to it.
- Do not install the product next to a sprinkler
sensor. The sprinkler may operate accidentally
because of the heat from the product.
- Do not install the product near high-tension wires.
The image on the screen may not be properly
displayed.
- Do not install the product near a heater. This may
cause product malfunction.
Wall-mount type
- Check whether the wall is stable enough to install
the product. If the wall is weak, it may cause an
accident. Reinforce the wall before installation.
- Secure enough space for cabling before finishing
the wall mounting process.
NOTE
Put down a panel slowly during installa-
y
tion to avoid panel damage by bumping
into each other.
When adjusting the interval between the
y
sets, make sure that the sets are bal-
anced vertically and horizontally. If the
set is tilted as shown in the figure, this
may cause damage to the product due to
interference between the edges.
Advertisement
Table of Contents
