Philips 32PFL5604H/12 Service Manual page 34

EN 34 6. Q543.3E LA
6.5 Reset of Repaired SSB
A very important issue towards a repaired SSB from a service
repair shop implies the reset of the NVM on the SSB.
A repaired SSB in service should get the service Set type
"00PF0000000000" and Production code "00000000000000".
Also the virgin bit is to be set. To set all this, you can use the
ComPair tool.
In case of a display replacement, reset the "Operation hours" to
"0", or to the operation hours of the replacement display.
6.5.1 SSB identification
When ordering a new SSB, please use the correct ordering
number. The 12nc SSB can be found on a sticker on the SSB
(see Figure 6-1). The 12 nc SSB is preceeded with an "S". The
ordering number of a "Service SSB" is the same as the ordering
number of a "Factory SSB".
The identification number of the SSB, as stored in NVM,
consists of fourteen characters and is built up as follows:
• seven last characters of the 12NC of the SSB itself
• the serial number of the SSB, which consists of seven
digits.
The serial number SSB and 12nc SSB both can be found on a
sticker on the SSB (see
2010-Jun-29
Alignments
Figure 6-1).
Serial number SSB
Figure 6-1 SSB identification
12NC SSB
18441_200_090429.eps
091208