Guest Mode: Measuring Without Pre-Set Data - Tanita BF-562 Instruction Manual

BF-562海外GB+D面付解除 ページ21

Guest Mode: Measuring without pre-set data

1 To set your details for
personal data.
While nothing is displayed,
Press
U
Following the display
instructions, record the
"month", "day" and "year" of
your "birth", and your
"gender" and "height".
See "Before Measurement
(Registration of Personal Data)" on
page 12 for details.
(Two short beeps will sound, then
"0.0 kg" will be displayed.)
Time/DOWN Button
Display
UP Button
SET Button
Front
GRAPH Button
Electrode
Heel Electrode
Points to Note
When you want to change the month, day, hour or minute,
please follow the same procedure as for the year.
When you find you have made a mistake during
temporary registration,
ePlease press the
GRAPH button. Since this operation
takes you back to the month setting, please start again.
When you want to quit while changing the calendar,
ePress
WEIGHT only/OFF button. The display will
disappear and the changes will be deleted.
20
2 To Start Measuring.
After 0.0 kg is displayed,
be sure to stand on the
scale platform barefoot so
that your heels touch the
center of the electrodes.
First "your body weight"
will be displayed.
(A short beep will sound.)
The body fat percentage
is being measured.
Them "ooooo" will appear
and disappear in succession,
Until the "Body Fat Percentage"
is displayed on the digital
display, move as little as
possible and stand straight.
Measurement is finished.
"your body weight" and the
"Body Fat Percentage" will
be displayed for about three
seconds. (Two short beeps
will sound.)
The BMI figure is displayed.
The unit will switch off.
Note: When measured in the
athlete-mode, the BMI figure
will not be displayed.
Remarks
Only change the calendar when necessary.
Please change the calendar only when the initial settings were
incorrect. If you change the calendar after that, the order of
the recorded measurement results may become mixed up.
How to Change the Calendar
Changing the calendar settings
1 Display the calendar.
While nothing is displayed,
press to
U
display the calendar.
2 Change the calendar.
e.g. In the case of changing the "Day".
Press
U
( "SET DATE" and "PRESS OR
" will be displayed.)
The display will show as the
diagram(right).
Highlight the calendar.
by pressing or
U U
Highlight the month.
by pressing or
U U
By pressing continuously,
U
Highlight the part you want to
change.
(In this case the "Year.")
Change the figure by pressing
or and set it by pressing
U U U
(The next item starts to flash.)
3 Finish changing
the calendar.
After the year, month and
day are displayed, "SET
TIME" and "PRESS OR
" will be displayed
(as right).
Highlight the clock by pressing
or
U U
Highlight the hour by pressing
or
U U
Highlight the
"Minute" by pressing
U
Press to set the calendar.
U
After "PRESS SET" flashes,
press again to finalize
U U
the calendar.
(After flashing, the display will
disappear.)
The calendar has been
changed.
Display
SET Button
UP Button
Time/DOWN Button
GRAPH Button
21