GRAUPNER PRX-3A Operating Manual page 14

PRX-3A
Power for Receiver
Using the PRX for the first time Using the PRX for the first time
At this point we assume that you have read and absorbed the complete operating instructions,
especially in respect of special notes, characteristics, voltage ranges and battery types.
In the following section we assume that your system incorporates
suitable batteries, and that they are fully charged.
Error states are described in the later section.
1. Select the appropriate battery type using the rotary switch on the PRX.
2. Select the appropriate output voltage by setting the rotary switch on the PRX
(can also be changed when the unit is in use).
3. Connect your battery (type as set) to the PRX (BAT), using the adapter lead
supplied if necessary.
4. Connect the output (RX) of the PRX to your receiver.
5. Switch the PRX on (ON). Never connect or disconnect batteries unless the PRX is
switched off (OFF).
6. When the unit is switched on, the input LED flashes green in the sequence which indicates
the code for the set battery type (BAT).
2 x flashes:
4 x flashes:
5 x flashes:
6 x flashes:
7. When the flashing sequence for the battery type is finished, the LED (BAT) glows a
constant green - assuming that the battery in use is fully charged.
8. If the LED (BAT) display a different flashing code from those described above,
it is indicating a warning or an error.
BAT
OFF / ON
Rotary switch
battery type
two-cell LiFe
two-cell LiPo
five-cell NiMH / NiCd
six-cell NiMH / NiCd or two-cell LiIon
LED BAT
14
RX
Rotary switch
output voltage