LG LRG3060 Series Owner's Manual page 45

Hide thumbs Also See for LRG3060 Series:
Table of Contents

Advertisement

Available languages

Available languages

Symptoms
The oven door does
The oven temperature is too high. Wait up to one hour for it to cool down.
not open after a Self
Clean cycle.
• Incorrect oven control settings. See Self Clean in the MAINTENANCE section.
The oven door is
• The oven was heavily soiled. Clean up heavy spills before beginning the Self
not clean after a Self
Clean cycle.
• The self clean cycle has been selected, but the door is not closed.
Clean and door flash
in the display
• Check the main gas shut-off valve or
oven control beeps
and displays an F
• Remove the power from the range
error code.
The oven racks were
Apply a small amount of vegetable oil to a paper towel and wipe the edges of the
cleaned in a Self
oven racks. Do not use lubricant sprays.
Clean cycle.
Power outage or surge. Reset the clock. If the oven was in use, you must reset
it by pressing the oven mode knob to the off position. Reset the clock and any
Clock is flashing.
cooking function.
This is normal in a new oven and will disappear with use. To speed the process,
"Burning" or "oily"
set a Self Clean cycle for a minimum of three hours. See Self Clean in the
odor emitting from the
MAINTENANCE section.
vent.
An odor from the insulation around the inside of the oven is normal for the first few
Strong odor.
times the oven is used.
• A convection fan may automatically turn on and off.
Fan noise
It is normal for the fan to operate periodically throughout a normal bake cycle in the
Fan operation
oven. This is to ensure even baking results.
Burners are not
Make sure that the burner heads and caps are completely dry and properly
lighting properly after
positioned.
cleaning the cooktop
surface.
When lighting just one
This is normal. Electric spark igniters from the burners cause the clicking noise. All
burner, clicking noise
the spark igniters on the cooktop will activate when igniting just one burner.
is heard from all the
burners.
Light can be seen
While the Broil function is running, it is normal to see a light between the oven air
through the oven air
vents.
vents.
possible Cause / Solutions
Clean cycle. Heavily soiled ovens may need either a longer Self Clean or two
Self Clean cycles.
- Close the oven door.
the oven gas shut-off valve and call
for service.
for five minutes and then reconnect
the power. If the function error code
repeats, call for service.
- This is normal.
TROUBLESHOOTING
CoDE
CaUSE
F-3
Key short error
F-9
Oven not heating
45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lrg3061 seriesLrg3193 seriesLrg3194 series

Table of Contents