Atco MP2 504 Series Operator's Manual page 41

13. MAINTENANCE TABLE
MACHINE
Check all fasteners
Safety checks/check controls
Check the rear discharge / side discharge guards.
Check the grass catcher, side discharge chute.
Check the cutting means
General cleaning and inspection
Checking for any damage to the machine. If necessary,
contact the authorised service centre.
Adjusting the converter cable
Replacing the cutting-means
ENGINE
Checking/topping up fuel level
Check/top-up engine oil
Air filter cleaning and check
Spark plug points cleaning and check
Replace the spark plug
Battery power reserve
* Check the engine manual.
** Operation to be performed at the first signs of any malfunction
*** The operation must be carried out by your Dealer or a specialized Service Centre
14. PROBLEM IDENTIFICATION
If problems persist after having performed the above operations, contact your dealer.
PROBLEM
1. The engine will not start
or will not keep running.
Intervention
PROBABLE CAUSE
Incorrect starting procedure.
No oil or fuel in the engine.
Dirty spark plug or incorrect
distance between the electrodes.
Air filter clogged.
Carburetion problems.
The lawnmower's fuel tank
was not emptied at the end
of the previous season
The float may be blocked.
Before each use
Before each use
Before each use
Before each use
Before each use
After each use
After each use
Before each use
Before each use
Follow the instructions (see chapter 6.3).
Check the oil and petrol levels.
Check the spark plug (Consult
the engine manual).
Clean and/or replace the filter
(Consult the engine manual).
Contact the authorised service centre.
Consult the engine manual and contact
the authorised service centre.
EN - 12
Frequency
**
-
*
*
*
*
SOLUTION
Notes
par. 7.5
par. 6.2
par. 6.2.1
par. 6.2.1
par. 6.2.1
par. 7.4
-
par. 7.7
par. 8.1 ***
par. 6.1.1 / 7.2 *
par. 6.1.1 / 7.3 *
*
*
*
par. 7.6 *