Starting The Program; Softkey Summary; Loading The Program From A Hard Disk - HP 85325A Operating And Service Manual

NOTE

Softkey Summary

NOTE
Loading the Program
From a Hard Disk

Starting The Program

indicate a front-panel key or on a computer key board.
[Brackets]
indicate a display softkey selection.
{Braces}
stops the current test or menu and returns to the last menu or the test
{ABORT}
menu. (It will take effect at the end of a sweep.)
selects the desired millimeter wave system to be tested. Make your
{MARK}
selection based on the appropriate number of test channels for your system.
allows you to test a different antenna measurement system.
{NEW DUT}
selects the test at the current cursor location.
{SELECT}
selects the test directly below the cursor.
{NEXT TEST}
selects the test by entering the corresponding number then pressing
{INPUT #}
.
[Enter]
Load the calibration software onto a hard disk. Refer "Install the
Performance Verification Software Onto a Hard Disk" on page 10 then
continue with the following procedure.
1. Turn on the computer and load HP BASIC.
2. Type,
MSI "ANT_PERF_VER:,700,0"
press .
[Enter]
3. Type,
press
LOAD "BOOTFILE"
type and press
RUN [Enter]
4. The program will now display the
of the following function keys depending on your setup:
displays the mass storage location that is currently selected. The
{Current}
location is displayed in the bottom left hand corner of the display. For
example:
ANT_PERF_VER:CS80,700
If this is the correct location of the program file select
if current mass storage location is not correct, select
{Other}
the correct location, then select
System Performance Verification
'(or an appropriate hard drive location) and
,
[Enter]
.
Mass Storage Selection Menu.
.
{Begin}
HP 85325A Operating and Service Manual 4-11
Starting The Program
Choose one
.
{Begin}
, enter
{Other}