Table of Contents
Advertisement
RB-6 L-801A (Airport) Rotating Beacon (Export)
Section 3
Installation
1. Introduction
2. Unpacking
3. RB-6 Beacon Installation
Mounting
2001 Siemens Airfield Solutions, Incorporated
All rights reserved
WARNING: Allow only qualified personnel to perform the
following tasks. Observe and follow the safety instructions in
this document and all other related documentation.
This section describes instructions for installing the RB-6 rotating beacon
(Export Version).
Handle equipment very carefully to prevent component damage. Note any
exterior damage to the carton/crate that might lead to detection of
equipment damage. Open the top of the carton/crate. Remove foam
packing from the top of the box. Carefully lift the unit out of the box by the
handles on the side of the motor box.
CAUTION: Do not lift the unit by the head. Failure to observe
this warning may result in equipment damage.
Unpack the carton/crate upon receipt and check the contents and their
condition. If you note any damage to any equipment, file a claim with the
carrier immediately. The carrier may need to inspect the equipment.
This subsection provides instructions for the installation of the RB-6
rotating beacon (Export Version). Refer to the project plans and
specifications for the specific installation instructions.
The RB-6 rotating beacon comes completely assembled except for
installation of a customer-supplied AWG 10, S0-3 power cord (not
supplied).
Remove the cover plate from the motor box. Inspect the interior to make
sure all parts are tight and have not been loosened in shipment. Reinstall
the cover plate. Mounting adapters furnished are for mounting on a level
surface with the following mounting dimensions: Three holes are tapped
1/2−13 UNC. If the surface is not level, spacers or shims will be needed.
Place a level on top of the motor box and use shims as necessary under the
four corners to bring the beacon to level. Tighten the mounting bolts, four
each #1/4 - 20 length as required.
96A0221B
Issued 5/01
Installation
Page 3-1
Advertisement
Table of Contents
