Registering And Deregistering Handsets - Binatone Pegasys 8 Triple Manual

USING THE PHONE

Registering and deregistering handsets

Your Pegasys 8 Triple is supplied with handsets 1, 2 and 3
already registered to the base unit, but if you have problems
using a handset, you may need to re-register it.
! Handsets must be registered to the main base unit; not to
a charger pod. Make sure you have charged the handset's
battery before trying to register it.
To register a 1 On the base unit, press the PAGE button and hold it for
handset about 3 seconds until the In Use/Charge light flashes
2 On the handset, press
You hear a 'beep' from the handset.
3 Key in the handset number (1, 2 or 3)
(The number is written on the front panel of the handset.)
4 Immediately place the handset in the base unit charging
cradle
The In Use lights on the base unit and handset flash for up to
30 seconds. If registration is successful, you then hear a
'beep' and both lights go out.
If you do not hear a 'beep' within about 30 seconds,
registration has failed. Try again, making sure that:
you use the correct handset number (as written on the
n
front panel)
you do not leave more than 15 seconds between key-
n
presses.
12
and together
TROUBLESHOOTING
If you have problems ...
! The Pegasys 8 Triple must be serviced by trained engineers.
NEVER attempt any repairs or adjustments yourself — you
could make the problem worse and invalidate the Guarantee.
ALWAYS check u you have followed the steps listed on pages 5 to 7 to install
first that: and set up your Pegasys 8 Triple
u all connectors are firmly inserted in their sockets
u the handsets' batteries are not run down
"I cannot make or If one or more handsets do not give Dial tone when you press
answer calls."
the button, follow the registration procedure on page 12.
Remember you can only use one handset at once. If one
handset is already connected on a call, you must wait until it
has finished before you can use another one.
Resetting the system
If you don't know what's causing the problem:
u Switch off power to the base unit and charger pods at the
mains sockets and/or unplug the mains power adapters.
u Remove the battery pack from the handset.
u Unplug the telephone line cord from the socket.
u Wait for 2 minutes, then replace the battery pack, reconnect
the telephone line plug and switch mains power back on to
the base unit and charger pods.
u Try again to make a call.
"I cannot register Make sure the handset's battery is fully charged.
my handset"
Do not leave more than 15 seconds between key-presses.
Make sure you are using the correct handset number, as
written on the front panel.
"I can't transfer Make sure the other handset is within range of the main base
a call" unit and is not in use.
Make sure you are keying in the correct number (1, 2 or 3)
for the other handset.
Binatone Help Line: 0208 344 8870, 9.00 am to 5.00 pm, Monday to Friday
13