C Preparation For Use; Antenna/Cable Connections - Sylvania 6313CD Owner's Manual

From Cable System or
Satellite Dish
Satellite Box or
Cable Box
O UT
(Not supplied)
From
Cable System
75-ohm Coaxial
Cable (Not supplied)
VHF/UHF COMBINED ANTENNA
The VHF/UHF Rod Antenna (supplied with 13"
model only) is detachable. Insert the stem of the
antenna into the hole on the upper-back portion of
the TV/VCR. Connect the VHF/UHF Rod Antenna or
VHF/UHF Combination Antenna to the ANT. termi-
nal of the TV/VCR as shown in the diagram above.
For the best reception, fully extend the VHF/UHF
Rod Antenna and make the necessary adjustments.
(Avoid touching the top section when adjusting.)
NOTE:
Before plugging the Rod antenna into antenna termi-
nal, check that the pin is not bent. If it is bent,
straighten the pin as illustrated, then plug the pin into
antenna terminal.
Bent pin
Cable Plug
(Needs to be straightened)
NOTE:
The connection of an indoor antenna may not always
give acceptable TV reception.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connect-
ed to the grounding system of the building as close to the point of cable entry as practical.
PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

Rod Antenna
(Supplied with 13" model only)
IN
ANT.
ANT.
or
(Straight pin)
or
VHF/UHF
Combiner
or
(Not supplied)
or
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor
antenna.
CABLE WITHOUT CONVERTER/
DESCRAMBLER BOX
Use this connection if your cable system connects
directly to your TV/VCR without a converter box.
By using this connection you can:
1) Use the TV/VCR remote to select channels.
2) Program one or more unscrambled channels for
Automatic Timer Recording.
NOTE: This unit will ONLY record and view the
same channel.
CABLE WITH CONVERTER/
DESCRAMBLER BOX OR SATELLITE
BOX
If your cable service supplies you with a converter
box or if you use a satellite system, you can use the
basic connection shown here.
By using this connection you can also record scram-
bled channels. However, channel selection must be
made with the converter box or satellite box. This
means that channels cannot be changed using the
TV/VCR Remote Control. Unattended timer record-
ing is limited to one channel at a time.
- 9 -
VHF/UHF Antenna
(Not supplied)
VHF Antenna
(Not supplied)
UHF Antenna
(Not supplied)
Flat twin-lead cable
EN
9I03