Page 1
OWNER’S MANUAL 13-INCH COLOR TV/VCR 6313CG INSTRUCCIONES EN ESPAÑOL INCLUIDAS. If you need additional assistance for set-up or operating after reading owner’s manual, please call TOLL FREE : 1-800-968-3429. Or visit our WEB SITE at http://www.SylvaniaConsumerElectronics.com Please read before using this equipment...
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE.
Page 3
EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECT RICAL CODE NEC - NATI O NAL EL ECTRI CAL CO DE S2 8 9 8 A 13.Outdoor Antenna grounding - If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is grounded so as to provide some protec- tion against voltage surges and built-up static charges.
LOCATION For safe operation and satisfactory performance of your unit, keep the following in mind when selecting a place for its installation: • Shield it from direct sunlight and keep it away from sources of intense heat. • Avoid dusty or humid places. •...
• Infrared remote control • Trilingual on screen menu display available in English, Spanish or French • This shows the elapsed record- Real time counter– ing or playback time in hours, minutes and sec- onds. The “–” indication will appear when the tape is rewound further than the tape counter position “0:00:00”.
OPERATING CONTROLS AND FUNCTIONS VIDEO AUDIO Connect to the Video output VIDEO input jack– jack of a video camera or VCR. Connect to the Audio output AUDIO input jack– jack of an audio equipment, video camera or VCR. Press to turn the unit on and off. POWER button–...
• Press to select a mode or figure from the setting menu. Press to start manual recording. RECORD button– Press to choose the desired SPEED button– recording speed:SP/SLP. Press to cancel a set- T-PROG. CLEAR button– ting of timer program. (Refer to page 24.) COUNTER RESET button–...
ANTENNA/CABLE CONNECTIONS Plug the incoming cable into the ANT. jack on the rear of the unit. If your cable service supplies you with a converter box or if you use a satellite system, connect the box with this unit as shown below. Cable Antenna TV signal...
USING FRONT A/V INPUT JACKS When you watch a program recorded on another source (VCR or video camera), use the AUDIO/VIDEO input jacks on the front of the unit. Connect the Audio/Video output jacks of another source to the AUDIO and VIDEO jacks of this unit.
CHANNEL SET UP Make sure ... • The unit must be turned on. AUTO CHANNEL PROGRAMMING As the initial setting, this unit has memorized all channels, including the ones not available in your area. This feature automatically puts only available channels into the memory.
PICTURE CONTROL The unit’s picture controls – BRIGHT, CON- TRAST, COLOR, TINT and SHARPNESS – are preset to factory specifications. Although they are usually the best, you may need to make some further adjustments for a more natural looking image. NOTE: •...
Select the hour Use [PLAY/ K K ] or [STOP/ L L ] until your desired hour appears. (Example: “05”, “PM”) Then press [F.FWD/ B B ]. Select the minute Use [PLAY/ K K ] or [STOP/ L L ] until the desired minute appears.
DAYLIGHT-SAVING TIME When Daylight-Saving Time is ON, the clock will change automatically as follows: • At 2 AM the clock imme- First Sunday of April : diately changes to 3 AM. Any timer programming you have set to occur between 2 AM and 3 AM will not record.
MENU LANGUAGE Select “LANGUAGE” Press [MENU]. Use [PLAY/ K K ] or [STOP/ L L ] to point to “LANGUAGE”. Select “ENGLISH”, “ESPAÑOL” or “FRANÇAIS” Use [REW/s s ] or [F.FWD/ B B ] repeatedly to select “ENGLISH”, “ESPAÑOL”= Spanish or “FRANÇAIS”= French.
V-CHIP SET UP This feature enables parents to prevent their children from watching inappropriate material on TV. When you try to access a program which is blocked, “PRO- TECTED PROGRAM by ...” message appears on the TV screen. V-CHIP SET UP Make sure ...
This unit will operate with any cassette that has the high-quality tapes. Do not use poor quality or damaged tapes. PRECAUTIONS • Avoid moisture. Moisture condensation may occur on the tape if it is moved from a cold place to a warm place or vice versa.
NORMAL PLAYBACK Make sure ... • The unit must be turned on. Insert a prerecorded tape If the erase-prevention tab has been removed, the unit will start playback automatically. To begin playback Press [PLAY/ K K ]. NOTE: • If any menu is activated on the screen, [PLAY/ K K ] does not func- tion.
Make sure ... • The unit must be turned on. • Insert a prerecorded tape. RENTAL PLAYBACK This function enables you to improve the picture quality when playing back worn cassettes such as rented tapes. Select “USER’S SET UP” Press [MENU]. Use [PLAY/ K K ] or [STOP/ L L ] to point to “USER’S SET UP”, then press [F.FWD/ B B ].
Make sure ... • The unit must be turned on. • Insert a tape. ZERO RETURN This function allows you to search easily a beginning point that you want to review by rewinding or fast forwarding. NOTE: • Zero Return WILL NOT work on a blank tape or a blank portion of a tape.
REAL TIME TAPE COUNTER This shows the elapsed recording or playback time in hours, minutes, and seconds. (The displayed time will not change on a blank tape or blank portions on the tape.) The “–” indication will appear when the tape has rewound further than “0:00:00”...
OTR (One Touch Recording) This function enables you to set a recording length simply by pressing [REC/OTR] on the unit. Make sure ... • The unit must be turned on. • Insert a cassette tape with its erase-prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.) NOTES:...
AUTOMATIC TIMER RECORDING You may set the unit to start and end a recording while you are away. You can set 8 programs to record on spe- cific days, daily or weekly within a 1 year period. In the example below, the timer is being set to record: DATE: July 3rd, 2006 SETTING TIME: from 7:30PM to 8:50PM...
Set end minute Use [PLAY/ K K ] or [STOP/ L L ] until the desired minute appears. (Example: “50” for 8:50PM) Then press [F.FWD/ B B ]. Set the tape speed Use [PLAY/ K K ] or [STOP/ L L ] until the desired tape speed appears.
STATUS DISPLAY On screen display examples are shown below. PLAY B 12:00AM COUNT 0:00:00 1. VCR status Displays the current VCR motion: PLAY / STOP / REC / OTR / PAUSE / FF / REW 2. Tape speed (during recording) Displays the tape speed: SP / SLP 3.
TROUBLESHOOTING GUIDE If you have followed the instructions contained in this manual and have difficulty in operating your unit, locate the PROBLEM in the left column below. Check the corresponding CORRECTIVE ACTION column to remedy the problem. PROBLEM No power. No picture or sound.
CONTROLES DE OPERACIÓN Y SUS FUNCIONES NOTA: No recomendamos utilizar mandos a distancia universales. No todas las funciones pueden ser controladas mediante un mando a distancia universal. Si decide utilizar un mando a distancia universal con esta unidad, tenga en cuenta que con el número de código dado tal vez no se pueda controlar la unidad.
Page 29
- MANDO A DISTANCIA - WAKE-UP POWER /SLEEP +100 MENU DISPLAY MUTE PLAY F.FWD STOP RECORD SPEED T-PROG. GAME CLEAR COUNTER RESET 15 Botón POWER– Presione para encender y apa- gar la unidad. Presione para activar la grabación con temporizador. 16 Botones numéricos–...
PREPARACIÓN PARA LA UTILIZACIÓN CONEXIONES DE ANTENA/CABLE Antena Señal de TV por cable Cable entrante desde Antena de Casa / Compañia de Cable (Sin Caja de Cable) (Caja de Cable o Caja de Satélite) Cable entrante desde Compañia de Cable o Antena de Satélite PARA MIRAR UN PROGRAMA DE TV Enchufe el cable eléctrico Enchufe el cable eléctrico de la unidad en un toma-...
Seleccione el año Presione [PLAY/ K ] o [STOP/ L ] hasta que aparezca el año deseado. (Ejemplo: “2006”) Presione [F.FWD/ B B ]. Seleccione la hora Presione [PLAY/ K ] o [STOP/ L ] hasta que aparezca la hora deseada. (Ejemplo: “05”, “PM”) Presione [F.FWD/ B B ].
FUNAI CORP. will repair this product, free of charge in the USA in the event of defect in materials or workman- ship as follows: DURATION: PARTS: FUNAI CORP. will provide parts to replace defective parts without charge for one (1) year from the date of original retail purchase.