Figure 288: Lift Arm Mounting Bolts; Figure 289: Drive Input Assembly Alignment - Precor AMT Series Service Manual

Figure 288: Lift Arm Mounting Bolts

27 Install the drive input assembly by aligning the bearing snap ring
opening with tab of the drive input housing.
28 Fasten the drive input assembly to the drive input housing using the
screw and square washer. Make sure that the square washer does not
contact the drive input pulley after installation, test by spinning
the drive input pulley through its full range.

Figure 289: Drive Input Assembly Alignment

29 Replace the drive input belt over the drive input pulley and the
step up pulley.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 336