Precor AMT Series Service Manual page 19

Hardware
Validation
Press the  key
Press the OK key
Vertical
Position Test
Press the CLEAR
key to return to
Hardware
Validation
Press the  key
Press the OK key.
Stride Count
Reset
Press the OK key
to CLEAR the stride
count.
Or
Press the CLEAR
key to cancel the
Stride Count Press
the OK key.Reset
and return to
Hardware
Validation.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
horizontal movement in both directions. At maximum
stride length the low stride display should read 0 and
the high stride display should read 40.
VERTICAL POSITION TEST will scroll across the
display.
Displays a digital representation of vertical
movement of the stairarms.
STRIDE COUNT RESET will scroll across the
display.
When STRIDE COUNT RESET is selected,
CONTINUE PEDALING, AND PRESS OK TO
RESET BELT STRIDE COUNT will scroll across the
display.
Note: The STRIDE COUNT
RESET is used to CLEAR the
stride count to zero only when
the support belts are replaced.
If the OK key is pressed, the software executes the
following steps.
1 Clears the LPCA belt stride count to
zero.
2 Increments the LPCA value to show
how many times the belt has been
replaced.
3
Log the odometer into LPCA with the
stride count of the last belt
replacement.
4 Clears the UPCA belt stride count to
zero.
5 Increments the UPCA value to show
how many times the belt has been
replaced.
6 Log the odometer into UPCA with the
stride count of the last belt
replacement.
Page 17