Establishing A Bluetooth Connection To The Mobile Telephone - Volkswagen 3C0 051 435 TA Operating Instructions Manual

4 Establishing a Bluetooth
After the connection of the Touch Adapter has been established with the mobile telephone integration
product (see also 2 Inserting the Touch Adapter and starting up), the connection between the Touch
Adapter and the mobile telephone must be established once via a Bluetooth
(coupling). After coupling, the mobile telephone is saved in the telephone list of the Touch adapter and
the mobile telephone integration product is available as a hands-free system.
After switching on the ignition or the Touch Adapter, a search is made for the mobile telephones saved.
First, always the last mobile telephone connected is searched for and then any other mobile telephones
saved. The Bluetooth
(see also Automatic connection Ÿ 7.1).
Carry out the coupling as described in the following. Read and observe the operating instructions of the
mobile telephone manufacturer as well as the settings on the mobile telephone.
−
Turn the mobile telephone and ignition on.
Automatic connection can be activated when coupling the first mobile telephone. When coupling further
mobile telephones, first Automatic connection must have been deactivated Ÿ More > Settings >
Bluetooth > Automatic connection.
−
Press the pushbutton
−
Activate the Bluetooth
in the surroundings. The mobile telephone presents a list of the devices found.
−
Select „Touch Adapter" on the mobile telephone.
−
Confirm the Bluetooth
A password request appears on the mobile telephone.
−
Enter the password „0000". If an incorrect password has been entered, the coupling process is
cancelled and you have to select the „Touch Adapter" device again in the list of devices found.
−
Depending on the mobile telephone, a question may be asked if this Bluetooth
be established in the future without entering the password again. Confirm this request with „Yes" to
enable the Bluetooth
The mobile telephone is now connected (coupled) to the Touch Adapter via Bluetooth
mobile telephone coupled as well as the mobile telephone network are displayed and the data is
transferred from the telephone book (SIM card) and the address book (telephone memory) to the Touch
Adapter. This may take a few seconds depending on the size of the data saved. If the synchronisation of
the telephone book is interrupted, e.g. by an incoming call, this may result in not all entries being
transferred. In this case, the telephone book can be resynchronised manually Ÿ More > Settings >
Device > Telephone book options > Load telephone book.
Note
●
Up to 10 different devices can be saved in the telephone list.
●
Certain settings may have to be carried out to the mobile telephone so that the mobile telephone
connects with the Touch Adapter automatically.
●
The telephone book of your mobile telephone is basically synchronised by the Touch Adapter in the
background at regular intervals.
●
Your saved telephone book data are only visible when your mobile telephone is coupled. Therefore,
this data is not visible for other Touch Adapter users.
●
Limits may occur with regard to the use of Bluetooth
concerning this can be obtained from your local authorities.
●
The Audio Streaming function (A2DP) of the mobile telephone integration product is not supported
by the Touch Adapter.
●
Depending on the mobile telephone as well as the navigation software used, the beginning of the
navigation announcements may be cut off due to technical reasons.
®
Bluetooth is a registered trademark of Bluetooth
® connection to the mobile telephone
®
connection is established automatically to the first mobile telephone detected
Connect telephone on the Touch Adapter.
®
function on the mobile telephone and start searching for Bluetooth
®
connection on the mobile telephone.
®
connection to be established automatically when turning on the ignition.
15
®
devices in many countries. Information
®
SIG, Inc.
®
radio connection
®
devices
®
connection should
®
. The name of the