Troubleshooting - Salton WC-2036 Instruction Booklet

TROUBLESHOOTING

You can solve many common appliance problems easily. Try the suggestions
below to see if you can solve the problem on your own.
PROBLEM
Appliance does not operate.
Appliance is not cold enough.
Appliance too cold.
Turns on and off frequently.
Vibrations.
The appliance seems to make too
much noise.
Condensation on front of door.
Moisture on exterior of appliance.
The door will not close properly.
Ice formation on the inner rear wall. • The door gasket does not seal properly.
POSSIBLE CAUSE
• Not plugged in.
• The circuit breaker tripped or a blown fuse.
• Check the temperature control setting.
• The door is opened too often.
• The door is not closed completely.
• The door gasket does not seal properly.
• Appliance is too close to a wall.
• Check temperature setting.
• The room temperature is too cold.
• The room temperature is hotter than normal.
• The door is opened too often.
• The door is not closed completely.
• The temperature control is not set correctly.
• The door gasket does not seal properly.
• Check to assure that the appliance is level.
(See 'Installation' section).
• The rattling noise may come from the flow of the
refrigerant, which is normal.
• As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your appliance.
• Contraction and expansion of the inside walls may
cause popping and crackling noises.
• The appliance is not level. (See 'Installation' section).
• Make sure the contents are not touching and are
placed correctly on the shelves.
• Room environment is too humid.
• Normal during periods of high humidity – wipe dry.
• The appliance is not level. (See 'Installation' section).
• The door was reversed and not properly installed.
• The gasket is dirty.
• The shelves are out of position.
• The door is opened too often or for too long.
8