Door Alignment - Salton CF-2029 Instruction Booklet

Proper Air Circulation
To ensure that your refrigerator works at maximum efficiency, you should
install it in a location where there is proper air circulation. The following
are recommended clearances around the refrigerator unit:
Sides 3/4" (19 mm)
Back 2" (51 mm)
Top 2" (51 mm)
Leveling Your Refrigerator
1. Your refrigerator has two leveling legs, which are located in the front
corners of your refrigerator.
2. Leveling legs can be adjusted by turning them clockwise to raise your
refrigerator or by turning them counterclockwise to lower your refrigerator.
The refrigerator door will close easier when the leveling legs are extended.

Door Alignment

1. Using a Phillips-head screwdriver, loosen the screws of the bottom hinge
by turning in a counter-clockwise direction.
2. Remove the bottom hinge bracket.
3. Adjust the door or put a spacer in between and then tighten the screws.
4. Replace the bottom hinge bracket.
Reversing the Door
1. Using a Phillips-head screwdriver, loosen the bottom hinge screws by
turning in a counter-clockwise direction. Remove the screws and
the bottom hinge bracket.
2. Holding the two sides of the door, pull the door down carefully.
3. Loosen and remove the screws on the top hinge bracket with
a Phillips-head screwdriver and remove the top hinge bracket.
4. Affix the top hinge bracket onto the screw hole of the opposite side.
Insert the screws into the opposite holes and turn in a clockwise direction,
but do not over-tighten.
5