Advertisement
REVERSIBLE DOOR
Your new refrigerator has been built to open from the right, however, it has
been designed to open from either side and can easily be changed by following
the procedure below. You will need a Philips (+) screwdriver for this. A putty
knife or other thin flat device can be used to remove the hinge covers.
Use care to prevent scratching the surfaces.
1. Unplug the Refrigerator from the wall
outlet and empty everything from
the Refrigerator door and shelves.
2. Remove the 2 top hinge covers
and the screw hole cover
on the door and set aside.
3. Place protective padding behind
the Refrigerator. Turn the Refrigerator on its back onto the protective padding.
4. Remove the six screws from the current hinges (three on the top,
and three on the bottom).
5. Transfer the hinges into the receptacle on the other side of the door.
Thread and secure the six screws in their new location. Replace
the hinge covers appropriately. See Diagram above.
CARE AND CLEANING
1. Unplug the refrigerator and remove the food and shelves.
2. Wash the inside with warm water and baking soda solution.
(2 tbsp./60 ml baking soda to 1 quart/litre of water).
3. Wash the shelf with mild detergent.
4. The exterior should be cleaned with a soft cloth dampened in mild
detergent and warm water.
5. Wring excess water out of the cloth before cleaning any areas that have
the controls or electrical parts.
6. Do not use abrasive cleansers which can damage or scratch the finish.
7. There is a filter on the outside back panel of the refrigerator. This should
be checked periodically to make sure that it is clean. If not, wash under
warm running water. Let dry, then place back into the filter holder.
5
Advertisement
