Table of Contents
Advertisement
Symptom
The power does not turn on.
The unit turns on automatically without
any operation.
P
The OSD Language Setting Menu appears
O
every time the power turns on.
W
E
R
The power turns off automatically .
Symptom
The unit does not function.
No picture, sound or menu appears on
G
the screen.
E
N
E
R
Clock Setting and Channel Setting cannot
A
be performed.
L
The unit does not operate properly.
The abnormal display appears
in the Front Panel Display.
130
Others
Troubleshooting (Cont'd)
Solution
• Check that the AC power cord is connected securely.
• Batteries of the remote control are weak.
• If above solutions do not work, press RESET on the front panel
with a sharp pointed object to re-start the unit. (See page 10.)
• During Auto Clock Setting, the POWER Light lights up.
• The unit turns on automatically 3 minutes before the Timer
Recording.
• Finish up the Language Setting procedure by selecting a
language in the OSD Language Setting Menu. Press ENTER to
activate the setting.
• The power turns off automatically when abnormality is
detected on the disc. Press POWER or OPEN / CLOSE A
to open the disc tray, and before it is opened completely, press
the button again. Then take out the disc.
• The power turns off automatically when an OTR is completed.
• There is a possibility that the safety device is working. Try
pressing RESET on the front panel with a sharp pointed object
to re-start the unit. (See page 10.)
Solution
•
or error message appears if the operation is prohibited.
• Batteries of the remote control are weak or exhausted
• There is a possibility that the safety device is working. Try
pressing RESET on the front panel with a sharp pointed object
to re-start the unit. (See page 10.)
• Check if the connections are made securely and correctly.
• Check if the cables are not damaged.
• Check if a correct external input channel is selected on your
TV. (See page 18.)
• Check if you have comleted the Channel Setting.
• If a Timer Recording is in standby or if a recording is in
progress, these operations cannot be performed. Delete timer
programs or stop the recording.
• Moisture has condensed inside the unit. Remove the disc and
leave the unit turned on for about two hours until the moisture
evaporates. (See page 4.)
• There is a possibility that the safety device is working. Try
pressing RESET on the front panel with a sharp pointed object
to re-start the unit. (See page 10.)
Advertisement
Table of Contents
