Rear View; Displayport Connector; Lan Connectors; Hdmi Connector - Sony PWS-110NM1 Operation Manual

c TEMP indicator
If an abnormally high temperature is detected within the
unit, the indicator turns on red.

Rear View

a SYSTEM TC connector
Not used by this system.
b Remote connectors (1/2, 3/4, 5)
Not used by this system.
c AC power supply units
Insert the power cords and connect to power outlets.
Only one AC power supply unit is installed at the factory.
A second optional power supply unit can be installed to
provide power supply redundancy. When used in systems
that require reliability, power supply redundancy allows
the unit to continue operating even if a power supply unit
fails.
For details about installing or replacing a power supply
unit, consult your Sony sales or service representative.
d USB connectors (rear panel)
USB devices not described in this document are not
supported.
Notes
• Of the four USB connectors on the rear panel, only the bottom right port
supports power delivery (900 mA). The other three ports do not support
power delivery, and should be used to connect USB devices that do not
require power supplied from the USB connector.
• Use SuperSpeed USB cables.
e LAN connectors
Connect to a Gigabit Ethernet network.
f HDMI connector
Connect to a monitor using an HDMI cable.
Use only Sony-brand HDMI cables.
1 1 2
LAN1 LAN2
4 5 4 6 7 8
Recommended cable (example): DLC-HE20XF
HIGH SPEED HDMI cable (2 m (6 ft.))
g DisplayPort connector
Connect to a monitor using a DisplayPort-to-DVI
converter cable or DisplayPort-to-HDMI converter cable.
Use an active-type converter cable.
Note
If using a DisplayPort cable, use the following recommended cable.
•
LINDY 41630 4K-compatible DisplayPort cable (1 m (3 ft.))
h Ground terminal
Connect to ground.
3
Name and Function of Parts
17