Table of Contents
Advertisement
(9)
Install the power assembly that was removed in step (2).
(10) Place the label (2) on the partition as shown in the figure.
(11) Install the AU-177, MD-83 and MS-37 boards that were removed in step (2) and the five plug-in
boards supplied with the BKP-7090 in order of board name markings on the label (2).
m
. The leftmost slot that is empty is for an optional board.
. If the camera is used together with the OHB-750WSA/750WSAP/730WS/730WSP, replace the
CN-1566 board, which has been connected to the DA-128 board, with the RC-68 board.
The RC-68 board is supplied with the OHB-750WSA/750WSAP/730WS/730WSP and switches
aspect ratio.
Partition
2 mm
Label(2)
EN
AD
PR
DA
MS
MD
AU
AT
(12) Connect the flexible card wire that was disconnected in step (3), to CN22 on the MB-764 board.
Reinstall the rear panel.
BKP-7090
PS
DA-128
1-2. Installing the BKP-7090 in the BVP-700/700P
Label(2)
Lever
Plug-in board
1-5 (E)
Advertisement
Table of Contents
