Related Manuals for Parkside PNS 300 B2
Summary of Contents for Parkside PNS 300 B2
- Page 1 2-SPEED POWER DRILL PNS 300 B2 2-SPEED POWER DRILL Original instructions IAN 321840...
-
Page 4: Table Of Contents
Table of contents 1. Introduction ............................Symbols used ....................................... Scope of delivery ...................................... Parts list ..........................................2. Technical data ............................ 3. Safety ..............................Proper use ........................................Residual risks ........................................ General safety instructions for power tools ..........................Safety warnings for drills .................................. -
Page 5: Introduction
The model name on the drill is a combination of letters and numbers: Congratulations on the purchase of your new PNS 300 B2 product. You have chosen a high quality product with this purchase. This operating manual is an integral part of this 2-speed mains-operated drill 2-Speed Power Drill (hereafter referred to only as the „drill“). -
Page 6: Safety
3. Safety General safety instructions for power tools Proper use WARNING! The drill is designed for the following purposes: Read all safety warnings, instructions, illustrations and - for screwing, specifications provided with this - for drilling in wood, plastic and metal. power tool. - Page 7 entering a power tool will increase the power tool on. A wrench or a key risk of electric shock. left attached to a rotating part of the power tool may result in personal d) Do not abuse the cord. Never injury.
-
Page 8: Safety Warnings For Drills
d) Store idle power tools out of Safety warnings for drills the reach of children and do not allow persons unfamiliar Safety instructions for all types with the power tool or these of work instructions to operate the a) Brace the tool properly before power tool. -
Page 9: Before Use
4. Before Use If the chuck does not lock by itself, turn the chuck ring. WARNING! Disconnect the machine from the Using the bit holder (Fig. D) mains before performing any maintenance or adjustments. You can use the bit holder after removing the chuck as described in the section „Removing Check the drill and scope of... -
Page 10: Speed Selection (Fig. F)
Speed selection (Fig. F) Work instructions NOTE! CAUTION! Operate the speed selection only Always secure your workpiece when the drill spindle is stationary. in a vice or in any other clamping Otherwise there is a risk of device. Secure particularly large damaging the gearbox. -
Page 11: Maintenance, Cleaning, Storage And Transport
6. Maintenance, cleaning, Cleaning storage and transport WARNING! Make sure that liquids do not get WARNING! inside the drill. Disconnect the machine from the mains before performing any • Clean the drill regularly with a dry cloth. Never maintenance or adjustments. use strong and / or abrasive cleaning agents or solvents. -
Page 12: Troubleshooting
7. Troubleshooting Problem Possible cause Rectification The drill does not start. Damaged cable. Check the cable. Fuse tripped. Check the household fuse box The carbon brushes are worn. Replace the carbon brushes. Trigger defective Have the trigger switch checked by customer service Poor drilling performance. -
Page 13: Noise And Vibrations Levels
8. Noise and vibrations 9. Recycling levels Disposal of packaging Noise emission levels Dispose of packaging separately. Dispose Tested according to EN 62841. The noise level of card and paper in waste paper, plastic at the workplace may exceed 80 dB (A); safety at collection points. -
Page 14: Warranty
11. Warranty instructions provided in the operating manual must be followed exactly for proper use of the product. The purpose of use and actions which Warranty provided by Walter are advised or warned against must necessarily Werkzeuge Salzburg GmbH be avoided. Dear customer, The product is intended solely for private use and This device comes with a 3 year warranty... - Page 16 Walter Werkzeuge Salzburg GmbH Gewerbeparkstr. 9 5081 Anif, Österreich V. 1.0 Last Information Update: 08/2019 IAN 321840...