Lighting - BMW S 1000XR Rider's Manual

the adjustment plate and into
the brake-caliper support and
the rear wheel.
Make sure that the quick-re-
lease axle fits into the recess
for the flats.
Insert left adjustment plate 1.
Install nut 2 with its washer,
but do not tighten the nut at
this point.
Secure the brake line in
holder 2 and install screw 1.
WARNING
Brake pads not lying against
the brake disc
Risk of accident due to delayed
braking effect.
Before driving, check that the
brakes respond without delay.
Operate the brake several
times until the brake pads are
bedded.
Adjust the chain tension
( 187).

Lighting

Replacing LED light
sources
WARNING
Vehicle overlooked in traffic
due to failure of the lights on
the vehicle
Safety risk
Always replace a faulty bulb at
the earliest possible opportun-
ity. Consult a specialist work-
shop, preferably an authorised
BMW Motorrad Retailer.
All light sources of the vehicle
are LED light sources. The
service life of the LED light
sources is longer than the
presumed vehicle service
life. If an LED light source
is faulty, please contact a
specialist workshop, preferably
an authorised BMW Motorrad
retailer.
9
179
z