Assembly; Operation - Hoover ONEPWR Series User Manual

Unpacking
This product requires assembly.
Carefully remove the product and any accessories from the box.
All the items listed on the back of the box must be included at
the time of purchase.
WARNING!
Items in this Assembly section are not assembled
to the product by the manufacturer and require cus-
tomer installation. Use of a product that may have
been improperly assembled could result in serious
personal injury.
If any parts are damaged or missing, please call 800-406-2005
for assistance.
WARNING!
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in
serious personal injury.
WARNING!
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification
is misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING!
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING!
Always remove battery pack from product when you
are assembling parts, making adjustments, cleaning
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING!
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
PG.5

ASSEMBLY

Wet/Dry Vac Assembly
See Figure 1, page 9
• Unlock the four locking latches and remove the lid.
• Remove the hose and attachments from the collection container.
NOTE: Make sure the filter is seated properly for dry
vacuuming. Remove the filter for wet vacuuming.
• Replace the lid and lock securely.
• Press the locking tab on the flexible hose and insert into
the vacuum port. Release the tab and make sure the
hose is secure.
• Attach the tapered end of the flexible hose into the
extension wand. Connect second extension wand and/or
accessories as needed.
• To remove, pull the extension wands and accessories
from the flexible hose.
• To remove the flexible hose, press the locking tab as
shown and pull away from the vacuum port.
NOTE: The flexible hose and accessories can be stored in
the collection container or on the lid of the wet/dry vac.

OPERATION

Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
Applications
You may use this product for the following purpose:
• Light-duty vacuuming of wet or dry surfaces.
Installing/Removing Battery Pack
See Figure 2, page 9
• Set the On/Off switch to the Off (0) position.
• Insert the battery pack into the product as shown.
• Make sure the latches on each side of the battery pack
snap into place and that the battery pack is secured in
the product before beginning operation.
• Depress the latches to remove the battery pack.
WARNING!