Cleaning And Maintenance - Dometic ECOLINE RH 430NTE Installation And Operating Manual

Cleaning and maintenance

➤ Place the cooling device on a firm base.
➤ Connect the connection cable to the AC mains supply.
✓ The cooling device starts cooling the interior.
➤ Set the temperature controller (fig. 1 1, page 3) to the desired temperature
(3 – 12 °C)
➤ If you wish to switch the cooling device off, pull out the connection cable
or ...
➤ Rotate the temperature controller (fig. 1 1, page 3) anti-clockwise to the OFF
position.
8 Cleaning and maintenance
!
WARNING!
Always disconnect the device from the power supply before you clean
and service it.
A
NOTICE! Risk of damage
• Never clean the cooling device under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooling device.
➤ Use a soft cloth, lukewarm water and a mild detergent to clean the inside of the
cooling device.
➤ Wash out the cooling device using clean water and dry thoroughly.
➤ At annual intervals, remove dust from the cooling aggregate at the back of the
cooling device using a brush or a soft cloth.
18
RH430, RH440
EN