Selecting Channels On The Receiver - Swann Wireless OutdoorCam SW231-WDC Operating Instructions Manual

Selecting Channels on the Receiver

Turning Channels ON or OFF
The Wireless Receiver is capable of receiving up to 4 separate channels. To turn on
channels move the dip switches on the receiver down to the ON position.
In the example below the receiver shows channel 1 is ON. No other channel will
appear other than Channel 1. Cameras will only appear on channels in the ON
position.
To activate channels move the channel
switch down to the ON position
Switching Between Active Channels
The front of the Wireless Receiver has 4 LEDs representing the 4 channels of the
receiver. When lit, the LED will indicate which channel is currently being displayed.
In the diagram below CH1 is lit up indicating Channel 1 will display on screen.
The Wireless Receiver allows you to manually switch between active channels by
pushing the SET button.
Note: The Wireless Receiver will only switch between active channels that have
been be set to the ON position as described above.
The Receiver has 4 lights indicating
the 4 channels of the Receiver
8 8 8
1 2 3 4 L
ON
The SET button will manually switch
between active channels
If switches are up, they are set to OFF
and cameras will not appear on screen