Siemens SIMATIC 870 V2 Quick Start Manual page 25

General specifications
Max. permissible current input per ISA slot
Max. permissible current input per PCI slot
Disk drives
Floppy drive
*2
Hard disk drive
CD–ROM, DVD–ROM/CD–RW
Graphics
Graphic controller
Graphic controller memory
Resolutions/frequencies/color depth
Interfaces
COM1
COM2
LPT1
DVI
Keyboard
Mouse
USB 2.0
PROFIBUS / MPI interface potential isolated
- Transmission rate
- Operating mode
- Physical interface
- Memory address area
- Interrupts
Ethernet
Status displays on device
1) Restriction for CD-ROM and DVD-ROM/CD-RW drives:
CD-ROM or DVD-ROM/CD-RW 10 to 58 Hz: 0.019 mm, 58 to 500 Hz: 2.5 m/s2
2) Restrictions for DVD-ROM/CD-RW: burner operation is only allowed without external
disruptions and at an ambient temperature between +5° C to +40°C
3) DC power supply only together with Pentium 4 Mobile 2.2 GHz processor
Panel PC 870 V2
QuickStart, Edition 03/2004, A5E00299738
5 V/ 2 A, 12 V/ 0.3 A, -12 V/ 0.05 A
5 V/ 2 A or 3.3 V/ 2A, 12 V/ 0.3 A, -12 V/ 0.05 A
The total power consumption (all slots) may not exceed 50 W
3.5" (1.44 MB) / 3.5"
3.5" EIDE, UDMA, for hard disk capacity, refer to the order
documentation
EIDE, UDMA33, for information on features, refer to the order
*2
documentation
VIA ProSavage8
Graphic memory 8, 16 or 32 MB SDRAM, uses system memory
CRT: up to 1600x1200 at 60 Hz / 16-bit colors
CRT: 1280 x 1024 at 100 Hz / 32-bit colors
LCD: 1280 x 1024 / 18-bit
Serial port 1, 25-pin D-sub connector
Serial port 2, 9-pin D-sub connector
Parallel port (standard, EPP mode)
Connection for printer with parallel port
Port for external CRT / LCD monitor
PS/2 keyboard connection
PS/2 mouse connection
2 x external at the interface side
9-pin d-sub socket
- 9.6 Kbps to 12 Mbps, configurable per SW
- potential isolated:
Data lines A,B
Control lines RTS AS, RTS_PG
5 V power supply (max. 90 mA)
- grounded:
Shielding of the DP12 cable
- RS485, potential isolated
- configured automatically
- configured automatically
Ethernet interface (RJ45), VIA MAC. VT6103 PHy
FD access (at the FD drive on the side of the housing)
CD-ROM access (at the CD drive, if installed)
Technical specifications
4.1 General specifications, computer unit
4-3