Siemens SIMATIC 870 V2 Quick Start Manual page 20

Starting up the device
3.4 Installing applications and drivers
8. Exit the operating system session and restart the computer unit. Otherwise the "Security
Figure 3-4
9. Click on the "Calibrate" button. The dialog for touch calibration will appear.
10. Touch the cross hairs on the touch screen for at least 3 seconds and no longer than 10
11. After installing the drivers and applications, exit the operating system session and restart
The installation of the drivers and applications is complete. For more information, please
refer to the chapter "Additional drivers and applications" in the control unit operating
instructions.
Notice
After starting up your device, find out more about the particulars of the operating system in
the chapter "Starting up" in the computer unit operating instructions. More information about
the Microsoft Windows operating system is located in the chapter "Maintenance and
Service" in the computer unit operating instructions.
3-6
features" from "KeyTools" or "KeyHook" will not be activated.
Warning
Use "KeyTools" as described in the chapter "Additional Drivers and Applications."
Applies after the deactivation of the "security features" of "Key Tools" or after the
deinstallation of "KeyHook":
When the additional function keys F13 and S16 are used, or when using your own key
code table, serious malfunctions of the user software can occur, because the key codes
behind the function keys can also be activated by activating keys other than the
configured ones.
The next two steps apply to control units with touch screen panels: After the computer
unit is restarted, the "Touch screen calibration" dialog will appear. Carry out the following
steps carefully:
Touch screen calibration
seconds. The "Calibration complete" dialog will appear. Exit the calibration by clicking on
the "Done" button.
the computer unit.
Panel PC 870 V2
QuickStart, Edition 03/2004, A5E00299738