Panasonic EYFLA5A Service Manual page 9

4.2. Initializing and Setting
NOTE:
• This section explains how to revert all tool settings to their default values at the time of shipment from the factory.
• The error display will be turned off.
 INITIALIZING ALL SETTINGS.
1. Set the tool to configuration mode.
(See the next procedure  SETTINGS THE TOOL TO
CONFIGURATION MODE.)
2. Press the format button.
a. The control panel will begin flashing.
DISPLAY: The letter "F" flashes on and off.
BATTERY INDICATION LAMP: The upper and lower
bars of the battery flash on and off.
3. Press the OK button to accept the selected setting.
a. The control panel will stop flashing and light up.
 SETTINGS THE TOOL TO CONFIGURATION MODE.
1. Turn off the control panel.
If the control panel is on, remove and then reinsert the
battery pack.
2. Engage the switch while pushing the button and then
release both the button and the switch.
a. After all the LED lamps have turned off, the control
panel will flash and change to configuration mode.
9