Panasonic EYFLA5A Service Manual page 14

Procedure 1A  1B  1C  1D  1E
Ref. No. 1E
Procedure 1A  1B  1C  1D  1E  1F Removal of Driving shaft assembly.
Ref. No. 1F
Removal of motor assembly.
1. Separate the motor assembly from the driving shaft assembly.
2. Take out the motor rotor assembly from the motor stator.
NOTE:
Make sure not to damage the magnet by motor rotor.
NOTE:
Make sure not to scratch FET circuit by motor rotor.
1. Take out two steel balls by pressing with vise.
NOTE:
Set another hammer on the reverse side next to the original ham-
mer.
When pressing the driving shaft assembly by vise, do not take out
the planet gear. If failure to do so it may crack the shaft.
2. Pull out two steel balls.
3. After removing steel balls, the assembled parts can be removed one
after another.
Hammer  29pcs of Steel balls  Thrust plate  Thrust plate  Cush-
ion rubber  Hammer spring  Spring fixing plate
balls may fall down.
4. Take out the pins something like a magnet and planet gears.
14