Creating File Systems - IBM System Storage TS7600 ProtecTIER Series Installation Roadmap Manual

Site 2 – Server B
ID
1 (eth3)
2 (eth4)
10. Type: q <enter>
11. Type: yes <enter>.

Creating file systems

Use this procedure to create file systems.
About this task
Creating files systems allows a repository to be created later.
Attention: If this is a 2 node cluster, the file systems must be created while one of
the nodes is powered off. Otherwise, creating the files systems will fail during the
build process. Once all of the file systems are created, power the other node back
on.
Procedure
1. Change directories to the /opt/dtc/app/sbin directory. Enter the command:
2. Confirm that the anticipated number of logical unit numbers (LUNs) are
3. Create the file system on the server. Enter the command:
Target Network Address
(Remote node's starting
network address)
The Available Options prompt displays a third time:
Available Options:
==================
(a)dd a new record
(e)dit a record
(d)elete a record
(c)ommit changes
(q)uit
Please Choose (a,e,d,c,q):
The message below displays:
Would you like to commit the changes performed to the routing table
now? (yes|no)
The Successfully committed changes! message displays, and you are
returned to the command prompt.
cd /opt/dtc/app/sbin <enter>
attached. Enter the command:
./fsCreate -u <enter>
A list of the valid multipath devices found, displays. The number of devices
found should match the predetermined number of devices planned.
./fsCreate -n <enter>
A message displays stating that any existing data on the disk storage will be
removed.
Target Netmask
(Remote node's netmask)
Chapter 8. Configuring ProtecTIER using ptconfig
Local Gateway Address
(The gateway address for
Server B at Site 2)
67