Honda CB1100 2017 Owner's Manual page 80

20161019161055_32MGC6500_eng_BOOK Page 80 Wednesday, October 19 2016 16:12:26 JST
Check rear axle alignment by making sure
5.
the rear end of the swingarm aligns with
the corresponding scale on the adjuster.
Both left and right swingarm ends should
align with the same mark on the
corresponding scale. If the axle is
misaligned, turn the left or right adjusting
bolt until the marks correspond.
Tighten the rear axle nut.
6.
Torque: 93 N·m (9.5 kgf·m, 69 lbf·ft)
Tighten the adjusting bolts lightly.
7.
Recheck drive chain slack.
8.
Drive Chain Adjusting the Drive Chain Slack
u
CB1100NA
Shift the transmission to Neutral. Stop the
1.
engine.
Place your motorcycle on its centre stand
2.
on a firm, level surface.
Loosen the rear axle nut.
3.
Loosen the lock nuts on both adjusting
4.
bolts.
Lock nut
Adjusting bolt
Rear axle nut/washer
Adjusting
plate
Scale
Continued
77