Honda CB1100 2017 Owner's Manual page 71

20161019161055_32MGC6500_eng_BOOK Page 71 Wednesday, October 19 2016 16:12:26 JST
Engine Oil Changing Engine Oil & Filter
u
Remove the oil filter with a filter wrench
6.
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
Discard the oil and oil filter at an
u
approved recycling centre.
Oil filter
Apply a thin coat of engine oil to the
7.
rubber seal of a new oil filter.
68
Install the new oil filter and tighten.
8.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft)
Install a new sealing washer onto the
9.
drain bolt. Tighten the drain bolt.
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Fill the crankcase with the recommended
10.
Rubber seal
oil (
cap.
Required oil
When changing oil & engine oil filter:
3.9 L (4.1 US qt, 3.4 Imp qt)
When changing oil only:
3.8 L (4.0 US qt, 3.3 Imp qt)
Check the oil level.
11.
Check that there are no oil leaks.
12.
P. 50, P. 126) and install the oil fill
2 2
P. 65
2