Cid 1743 Fmi 02 Engine Speed Mode Selection Switch State, Invalid State; Cid 1894 Fmi 02 Set Speed Control Disengage Switch State, Invalid State; Cid 1895 Fmi 02 Set Speed Control Speed Toggle Switch, Invalid State - Perkins 1104E Series Troubleshooting Manual

RENR2696-01
Results:
•
OK – STOP.
CID 1743 FMI 02 Engine Speed
Mode Selection Switch State,
Invalid State
Conditions Which Generate This Code:
The ECM has detected one of the following
conditions:
•
Erratic data
•
Intermittent data
• Incorrect data
System Response:
The ECM will return the engine to the last good
mode selection or setting. The ECM will not allow the
engine to advance to another mode selection until
the problem is repaired.
Possible Performance Effect:
The engine will start but the engine will have reduced
engine speed.
Troubleshooting:
Refer to Troubleshooting, "Mode Selection Circuit -
Test".
Results:
•
OK – STOP.
CID 1894 FMI 02 Set Speed
Control Disengage Switch
State, Invalid State
Conditions Which Generate This Code:
The ECM detects one of the following conditions:
•
Erratic data
•
Intermittent data
•
Incorrect data
System Response:
The engine speed fails to disengage from the set
i01798179
speed.
The ECM will log the diagnostic code. The diagnostic
code may be viewed on the electronic service tool.
The ECM will have no response to this active code.
There is no loss of engine performance.
Troubleshooting:
Further troubleshooting is required.
Refer to Troubleshooting, "Throttle Switch Circuit -
Test".
Results:
•
OK – STOP.
CID 1895 FMI 02 Set Speed
Control Speed Toggle Switch,
Invalid State
Conditions Which Generate This Code:
The ECM detects one of the following conditions:
•
Erratic data
•
Intermittent data
•
Incorrect data
System Response:
The engine speed fails to disengage from the set
i01798180
speed.
The ECM will log the diagnostic code. The diagnostic
code may be viewed on the electronic service tool.
The ECM will have no response to this active code.
There is no loss of engine performance.
Troubleshooting:
Further troubleshooting is required.
Refer to Troubleshooting, "Throttle Switch Circuit -
Test".
83
Troubleshooting Section
i01798181