Speedometer Tube Routing; Digital Speedometer Set Up - Yamaha F70AET Rigging Manual

SPEEDOMETER

SPEEDOMETER TUBE ROUTING

1. Cut off about 3 mm (0.12 in.) from the end
of the nipple of the speedometer tube to
open it.
2. Route the speedometer tube carefully to
avoid crimping or damage.
3. Connect the tube to the nipple.
* The optional speed sensor (P/N: 688-83556-
01) is required if the speedometer tube is not
equipped to the clamp bracket area.
* In high-performance applications where the
engine has been mounted in an elevated
position, it may be necessary to use the
optional speed sensor to obtain a correct
reading.
(1) Optional speed sensor

DIGITAL SPEEDOMETER SET UP

1. Remove the rubber grommet from the back
2. Set the toggle dipswitches in the chart as
3. Reinstall the grommet.
Cut off 3 mm
(0.12 in.)
Display
SW.3
SW.4
Fuel
sensor
* The switch position in the illustration shows the
initial setting, which is the mph display and ABYC
fuel sensor.
5-11
of the meter.
below.
SW.1 ON
SW.2 ON
km/h
ON
ON
Yamaha
original
5 – 105 Ω 30 – 240 Ω
OFF OFF
ON OFF
mph knot/h
OFF OFF
ON OFF
ABYC
Europe
(US)
180 – 0 Ω