Mounting On Rotary Actuator - ABB PositionMaster EDP300 Manual

PositionMaster EDP300 DIGITAL POSITIONER | CI/EDP300-EN REV. D

Mounting on rotary actuator

For mounting on part-turn actuators in accordance with
VDI / VDE 3845, the following attachment kit is available:
6
Figure 15: Components of attachment kit
• Adapter with spring
1
• four M6 screws each
4
to fasten the attachment bracket 6 to the positioner
• four M5 screws , Spring washers
7
fasten the attachment bracket to the actuator
Required tools:
• Wrench, size 8 / 10
• Allen key, size 3
1
5
7
8
9
M10130-01
5
, spring washers and washers
3
and washers
8
2
3
4
Figure 16: Mounting the adapter on the positioner
1. Determine the mounting position
(parallel to actuator or at 90° angle)
2. Calculate the rotational direction of the actuator
(right or left).
3. Move the part-turn actuator into the home position.
4. Pre-adjust feedback shaft.
 To make sure that the positioner runs within the operating
2 range (refer to General on page 16), the mounting position as
well as the basic position and rotation direction of the
to
9 actuator must be considered when determining the adapter
position on axis
be adjusted manually so that the adapter
in the correct position.
5. Place the adapter in the proper position on the feedback
shaft and fasten with threaded pins
pins must be locked in place on the flat side of the feedback
shaft.
3 2 1
. For this purpose, the feedback shaft can
1
. One of the threaded
2
21
M10424-01
can be attached
3