Safety Sign Locations - Meridian SLMD10 Safety And Operation Manual

SAFETY SIGN LOCATIONS

CAUTION
1. Do not operate this auger before reading and
understanding the operator's manual.
2. Do not operate this auger unless all guards and
safety devices are securely in place.
3. Do not adjust, service, lubricate, clean, unclog or
move this unit until all power has been shut off.
4. Make certain everyone is clear of the equipment
before moving or operating. Never allow children,
visitors or untrained personnel in the area.
5. Keep hands, feet and clothing clear of all moving
parts while in operation.
6. Support discharge end or anchor intake end to
prevent upending.
7. Empty auger and lower to transport position before
moving to prevent upending.
8. Lower this unit to transport position when not in use.
9. When raising or lowering auger watch for overhead
powerlines and other obstructions.
10. Disengage belt tension release on motor base before
starting motor.
11. Disconnect power on electric motor driven units
before resetting motor overload, make certain
electric motors are properly grounded.
12. Always make certain that trained personnel are in
attendance while unit is in operation.
DANGER
Upending Hazard
The intake end of the grain auger must
always have downward weight.
Always test it before releasing it from
the vehicle or holddown.
Lift the intake slowly and keep it no
higher than the tractor tow bar when
attaching or releasing it.
Immediately lower the auger to
transport position before moving.
Failure to do so will cause upending,
which will result in serious injury or death.
CAUTION
CLOSE VALVE IN THE LIFT
CYLINDER HYDRAULIC LINE
AFTER RAISING AUGER
INTO POSITION
SAFETY
B13
13000004526-17-00
WARNING
To Prevent Serious Injury or Death
-Avoid unsafe operation or
maintenance.
-Do not operate or work on this
machine without reading and
understanding the operator's
manual.
-If manual is lost, contact your
nearest dealer for a new manual.
DANGER
ELECTROCUTION HAZARD
To prevent serious injury or death from
electrocution:
-Stay away from overhead powerlines
when transporting or raising augers.
This machine is not grounded.
Electrocution can occur without direct
contact.