Maintaining Your Iron - Sunbeam 3982 User Manual

C
ARING FOR
T O
URNING FF
1 Turn the small Steam dial to Dry/O and the large Fabric/Temperature dial to Off/O.
2. Unplug the iron from the power source.
WARNING: NEVER yank the power cord when unplugging the iron, this can damage the cord.
S Y
TORING OUR
1. Allow the iron to cool.
2. If you do not use your iron on a daily basis, empty the water reservoir after each use
for a longer iron life. To do so, turn the iron upside down to allow water to flow from
the fill hole. Shake the iron gently to remove trapped water drops. Close the water
reservoir cover.
3. Loosely loop the power cord together and store the iron on its heel rest.
IMPORTANT: Wrapping the cord around the iron too tightly can damage the cord.
TIP: When not ironing, always set the small Steam dial to Dry/O and the large
Fabric/Temperature dial to Off/O.
M
C
LEANING THE
Clean the soleplate if starch or other residue accumulate.
To clean the Soleplate:
1. Allow the iron to cool and then wipe it with a soft, damp cloth.
WARNING: DO NOT use abrasive cleansers, scouring pads or vinegar to clean the soleplate.
This will damage the finish.
2. Run the iron over an all-cotton cloth to remove any residue.
C
LEANING THE
THIS PROCEDURE CLEANS THE IRON'S STEAM VALVE, STEAM VENTS,
AND STEAM CHAMBER OF MINERALS THAT CAN CLOG YOUR IRON,
AND REDUCE ITS STEAMING AND HEATING CAPABILITIES.
The Steam valve/Steam dial is removable for easy cleaning. Cleaning the iron is
only necessary if you notice a reduction in steam. Use the following procedure
to reduce the mineral build up:
• Set Steam dial to OFF position.
• Fill the iron's water tank to its maximum level.
• Set the temperature selector knob to its highest setting.
• Allow the iron to heat for 1-1/2 minutes.
Y
OUR
Y I
OUR RON
I
RON
AINTAINING
S
OLEPLATE
I R
RON TO EDUCE
I
RON
Y
OUR
M
INERAL
English-5
A U
FTER
I
RON
B U
UILD P
SE