Table of Contents
Advertisement
[Caption] (video printers only)
Select whether to print a caption.
The default setting is [Not Used].
[Caption Content] (video printers only)
Select the content of the caption to be printed.
You can select from [Rec Date] and [Date and Patient
ID].
The default setting is [Rec Date].
2
Display the [Print 2] tab, and configure settings
related to paper size and print quantity.
The setting items that you can configure will vary
depending on your printer.
[Paper]
Select the printer's paper size.
The default setting will vary depending on your
printer.
[Orientation]
Select the orientation for printing.
The default setting is [Portrait].
[Copies]
Specify the number of copies to print (1 to 10).
The default setting is [1].
Tip
When using a UP-D25MD or video printer, the
[Paper] and [Orientation] settings are disabled and
cannot be configured. When using a video printer,
[Copies] will also be fixed at [1].
3
To configure screen display settings, proceed to
"Configuring Other Settings" (page 39).
If you are finished configuring settings, select
[Apply] and press the ENTER button.
Configuring Other Settings
Configure settings related to the screen displays.
1
Display the [Other] tab, and configure the following
settings.
[Menu Display]
Select 2D or 3D for the menu screen display format.
The default setting is [2D].
[Select Right/Left of Image]
Select which image (left or right) to use for Ch2
recorded data when recording still images or
recording simultaneously.
The default setting is [Left].
2
To configure settings for the PinP function, proceed
to "Configuring PinP Settings" (page 39).
If you are finished configuring settings, select
[Apply] and press the ENTER button.
Configuring PinP Settings
Configure settings related to the PinP (picture-in-picture)
function.
For details on the PinP function, see "Superimposing
Vitals Data Images (PinP)" (page 53).
1
Display the [PinP] tab, and configure the following
settings.
[PinP]
Select whether to superimpose the RGB input signal
image as a PinP.
You can select from [Not Used], [Ch1], [Ch2], and
[Ch1+Ch2].
When [Ch1+Ch2] is selected, the RGB input signal is
superimposed on both the Ch1 and Ch2 images.
The default setting is [Not Used].
Tip
When [Ch2 Rec] and [Streaming] are set to [Not
Used] in the [Rec/Streaming] tab, the image is not
superimposed on the Ch2 image. Even if [Ch1+Ch2]
is selected, the image will only be superimposed on
the Ch1 image.
[Position]
Select the position of the inset image.
You can select from [Upper Left], [Upper Right],
[Lower Left], and [Lower Right].
The default setting is [Upper Left].
[Size]
Select the size of the inset image.
You can select from [1/3] and [1/4].
The default setting is [1/4].
2
When you finish configuration, select [Apply] and
press the ENTER button.
The [Settings] screen appears again.
39
Advertisement
Table of Contents
