Related Manuals for Fisher & Paykel DCS RF24R
Summary of Contents for Fisher & Paykel DCS RF24R
- Page 1 OUTDOOR REFRIGERATOR AND BEER DISPENSER Use and Care and Installation Guide MODELS: RF24R RF24T...
- Page 3 A MESSAGE TO OUR CUSTOMERS Thank you for selecting this DCS Outdoor Refrigerator/Beer Dispenser. Because of these appliances’ unique features we have developed this Use and Care and Installation Guide. It contains valuable information on how to properly install, operate and maintain your new appliance for years of safe and enjoyable operation. To help serve you better, please fill out and submit your Product Registration by visiting our website at www.dcsappliances.com and selecting “Customer Care”...
-
Page 4: Table Of Contents
TABLE OF CONTENTS SAFETY PRACTICES AND PRECAUTIONS INSTALLATION - ESSENTIAL REQUIREMENTS INSTALLATION Electrical connection How to install your outdoor refrigerator/beer dispenser How to install your outdoor beer dispenser components 8-11 Tapping procedures USING THE REFRIGERATOR/BEER DISPENSER 13-16 CARE AND MAINTENANCE How to clean and maintain your unit Replace interior light bulb Things to remember... -
Page 5: Safety Practices And Precautions
SAFETY PRACTICES & PRECAUTIONS To reduce the risk of fire, electric shock, or injury to persons read these SAFETY PRACTICES AND PRECAUTIONS before operating this appliance. Use this appliance only for its intended purpose as described in this User Guide. WARNING When using this appliance always exercise basic safety precautions including the following: DANGER! -
Page 6: Installation - Essential Requirements
INSTALLATION – ESSENTIAL REQUIREMENTS POWER I The appliance must be installed so the power plug is accessible. I To ensure that the appliance is not accidentally switched off, connect your refrigerator/beer dispenser to its own power point. Do not plug in any other appliance at this power point or use extension cords, or double adapters, as the combined weight of both power cords can pull the double adapter from a wall outlet socket. -
Page 7: Installation
INSTALLATION HOW TO INSTALL YOUR OUTDOOR REFRIGERATOR/BEER DISPENSER ELECTRICAL CONNECTION: Check serial plate for correct power supply. Use only electrical power supply as specified on your appliance serial nameplate. Do not use an extension cord! WARNING! Do not splash or spray water from a hose onto the refrigerator! Doing so may cause an electrical shock, which may result in severe injury or death. - Page 8 INSTALLATION HOW TO INSTALL YOUR OUTDOOR REFRIGERATOR/BEER DISPENSER SELECT LOCATION: The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out of direct sunlight, away from heat sources and moisture. Units with fan cooled condensers can be built in. Unit should be operated in a properly ventilated area with ambient temperatures above 40 degrees and below 100 degrees Fahrenheit.
- Page 9 INSTALLATION HOW TO INSTALL YOUR OUTDOOR REFRIGERATOR/BEER DISPENSER ISLAND BEER DISPENSER INSTALLATION: When installing the Beer Dispenser under a counter and using a remote location for the Dispenser Tower, follow instructions below. Steps need to be taken to insure proper temperatures are maintained in the dispenser. IMPORTANT: All holes must be sealed to prevent air leak.
-
Page 10: How To Install Your Outdoor Beer Dispenser Components
INSTALLATION HOW TO INSTALL YOUR OUTDOOR BEER DISPENSER COMPONENTS Contents of Kit: Tools needed: Draft Tower Assembly Crescent Wrench Keg Coupler Pliers Air Line with Clamps Screwdriver Single Gauge Regulator 5 lb. CO Empty Cylinder Q. WHAT SIZE KEG WILL FIT INTO MY REFRIGERATOR? Approximate measurements required to tap most kegs: Quarter Barrel Half Barrel... - Page 11 INSTALLATION HOW TO INSTALL YOUR OUTDOOR BEER DISPENSER COMPONENTS WARNING! can be dangerous. 1. ALWAYS connect CO gas cylinder to reducing valve or regualtor. 2. NEVER connect gas cylinder directly to keg. 3. ALWAYS secure gas cylinder in upright position. 4.
- Page 12 INSTALLATION HOW TO INSTALL YOUR OUTDOOR BEER DISPENSER COMPONENTS ASSEMBLE AND CONNECT PARTS 1 . Screw the black faucet knob onto the faucet (Fig. 06). 2. Mount the draft tower onto the counter top using the four furnished screws and the one mounting gasket (Fig.
-
Page 13: How To Install Your Outdoor Beer Dispenser Components
INSTALLATION HOW TO INSTALL YOUR OUTDOOR BEER DISPENSER COMPONENTS PARTS OF A CO REGULATOR 1. Pressure gauge (reads the amount of internal keg pressure). 2. Regulator adjustment screw (after keg is tapped, screw clockwise until pressure gauge indicates between 12 and 14 lbs.). 3. -
Page 14: Tapping Procedures
INSTALLATION TAPPING PROCEDURES LEVER TYPE KEG COUPLER (Taps most major domestic brands) . Align lug locks on tap head . Turn tap head handle 1/4 . Pull tap handle out and with lug housing in top of turn clockwise; the tap push down to open beer keg;... - Page 15 USING THE BEER DISPENSER TEMPERATURE CONTROL Initially set the cold control knob midway between the numbers. After at least 2 hours, adjust to the temperature that suits you. The higher the number you select, the cooler the temperature (Fig. 17). The temperature control knob is located at the bottom front of the cabinet, just behind the square opening near the middle of the venting grill.
- Page 16 USING THE REFRIGERATOR CONTROL Door Switch Control NOTE Figure 3 During initial startup, or anytime power is interrupted, there steady amber color. “hi” indicates that the temperature is 10° F will be an approximate 5 minute delay before the refrigerator (5.5°C) above the set point and “Lo”...
- Page 17 ADDITIONAL REFRIGERATOR CONTROL FEATURES Information Menu: Keypad Lockout Feature (Loc): This feature is useful for prohibiting changes in the The following features are available on the Information Menu. temperature set point or accidentally turning the unit o . Press and hold the “SET” key to display the cur- rent “Loc”...
-
Page 18: Using The Refrigerator/Beer Dispenser
USING THE REFRIGERATOR/BEER DISPENSER DRAW A GLASS OF BEER Start with a clean beer After the glass has Let the remaining Close the faucet glass that has been reached half full, beer run straight completely and wetted in cold water. gradually bring the down the middle. -
Page 19: Care And Maintenance
CARE AND MAINTENANCE HOW TO CLEAN AND MAINTAIN YOUR UNIT Condenser The condenser coil under the cabinet for forced air unit does require frequent cleaning. Satisfactory cooling depends on adequate ventilation over the condenser coil. Be sure that nothing obstructs the air flow openings in the lower front of the cabinet. -
Page 20: Replace Interior Light Bulb
CARE AND MAINTENANCE REPLACE INTERIOR LIGHT BULB When supplied with an interior light, your refrigerator uses a 15 Watt appliance light bulb. To replace the light bulb, proceed as follows: 1. Unplug the power cord from the power supply. 2. Open the cabinet door, the light bulb is located behind the display housing at the top of the unit. 3. -
Page 21: Moving Or Storing Your Refrigerator
MOVING OR STORING YOUR REFRIGERATOR If your refrigerator or beer dispenser is turned off for any reason, wait 10 minutes before turning it back on. This will allow the refrigeration system pressures to equalize before restarting. MOVING YOUR REFRIGERATOR OR BEER DISPENSER I Turn off the appliance and unplug from the power point. -
Page 22: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE/SOLUTIONS ODOR IN CABINET Interior needs cleaning Cabinet not level NOISY OPERATION Fan blade damaged. Call for service Cabinet not level CABINET VIBRATES Fan blade damaged. Call for service Bulb burned out CABINET LIGHT NOT WORKING (OPTIONAL FEATURE) Open door switch. -
Page 23: Troubleshooting
TROUBLESHOOTING COMMON DRAFT PROBLEM PROBLEM DESCRIPTION CAUSES Beer drown improperly Creeping regulator Applied pressure is set too high Hot spots in line Beer, when drawn, is all Use of non-insulated beer line foam, or too much foam WILD BEER and not enough liquid Beer runs are too long for proper cooling beer. -
Page 24: Service
SERVICE HOW TO OBTAIN SERVICE: For warranty service, please contact your local service provider or DCS Customer Care at (888) 936-7872. Before you call, please have the following information ready: Model Number (the serial plate is located on the upper left side, inner wall). Serial Number (the serial plate is located on the upper left side, inner wall). -
Page 25: Warranty
WARRANTY LIMITED WARRANTY When you purchase any new DCS Refrigeration Product, you automatically receive a One Year Limited Warranty covering parts and labor for servicing within the 48 mainland United States, Hawaii, Washington, D.C. and Canada. In Alaska the Limited Warranty is the same except that you must pay to ship the Product to the service shop or for the service technician’s travel to your home. - Page 26 WARRANTY 7. Noise and vibration that is considered normal e.g. drain sounds, regeneration noises and user warning beeps. 8. Correcting damage caused by pests e.g. rats, cockroaches etc. 9. Used in commercial applications. B. Defects caused by factors other than: 1.