Wiring Components - Siemens SIMATIC VS130-2vcr Installation Instructions Manual

Wiring Components

Connect the processing unit with the other components using the connectors on the front
panel. The pinning of the connectors is described in Appendix 8.5.
Attention
!
Do not connect or disconnect cables when the power supply is on.
Apart from the Ethernet cable, the cables are supplied with the product (See Appendix 8.1).
Warning
!
Grounding the VS130-2/VS 130-2vcr cancels the ungrounded installation of the power unit
used to operate the VS130-2/VS 130-2vcr.
IN DC 24V LAMP
Connector Connector Type
Label
Functional earth - Screw terminal
Power supply IN 24 V DC Circular connector M12
Lighting Unit LAMP Circular connector M12
Sensor head SENSOR HD D-sub *
(shielded cable)
I/O DI/DO D-sub
PROFIBUS DP DP D-sub
Ethernet Ethernet RJ45
* The supplied ferrite ring must be fixed to the sensor cable (approx. 50 mm from connector
to processing unit).
Vision Sensor SIMATIC VS 130-2/VS 130-2vcr - Installation Instructions
A5E00475766-01
DP ETHERNET
Number Cable Type
of pins Cross
Section
- - -
2
4 0.56 mm Pin
2
4 0.23 mm Socket
2
26 0.09 mm Socket
2
15 0.14 mm Socket
9 - Socket
8 - Socket
Step Activity
1 Read the guidelines on preventing electrical interference (refer to the manual, Section 3.3).
2 Connect the processing unit to the sensor head and the lighting unit with the cables.
3 If you do not evaluate the result bits READ, MATCH, N_OK over PROFIBUS DP: Connect
the digital outputs READ, MATCH, N_OK as described below ("DI/DO" I/O interface).
4 Connect the trigger signal via the TRG digital input.
5 If you intend to control the SIMATIC VS130-2/VS 130-2vcr with a PLC via the I/O interface
"DI/DO", connect the other digital inputs and outputs as described below (DI/DO interface).
6 Connect functional ground of the processing unit to chassis ground
(Diameter of the ring: (M5, cable cross section 1.5 mm
7 Connect the processing unit to the 24 V power supply (2 A).
8
Connect the PC/PG to the processing unit via Ethernet.
If you want to use this connection as a direct connection, please note that a crossover cable
is necessary.
Note
The DC load power supply must meet the following requirements:
Only low voltage less than or equal to 24 V DC safely isolated from the power
supply network must be used for the load current supply. Safe isolation can be
implemented, for example, by adhering to the specifications in VDE 0100-410 /
HD 384-4-41 S2 / IEC 60364-4-41 (functional low voltage with safe isolation) or
VDE 0805 / EN 60950 / IEC 60950
(as safety extra-low voltage SELV) or VDE 0106 Part 101.
Note
The supply chassis of the I/O and CPU must be connected to the supply chassis
of the processing unit.
2
).
3