Resetting The Safety Auto Shut Off; Care And Cleaning - Sunbeam HE2800 Instruction Booklet

Resetting the safety auto shut off

Your Oscillating Digital Ceramic heater is
equipped with a safety system that detects
any abnormally high temperatures within the
heater and automatically shuts it off to
prevent overheating. Should the safety auto
shut off activate and switch the heater off, it
will need to be reset.

Care and cleaning

Ensure that the heater is switched off and
disconnected from the power outlet before
cleaning.
Carefully wipe the exterior of the heater with
a soft damp cloth and dry thoroughly with a
dry cloth.
8
To reset the heater:
1. Move the on/off switch at the rear of the
heater to the off position (O).
2. Unplug the heater and wait 5-10 minutes
for the unit to cool down.
3. After 5-10 minutes, plug the heater in
again and operate as usual.
Over timer dust may accumulate on the front
vent of the heater, this can be removed by
wiping with a damp cloth, or carefully going
across the vent with a vacuum cleaner with
brush attachment.
Do not use harsh or abrasive cleaners to
clean your heater, as these will damage the
surface.